Ningbo FET Building Materials and Technology Co.,Ltd
Ningbo FET Building Materials and Technology Co.,Ltd
Add to Cart
Moisture and Water Resistant Light Weight and Earthquake Resistance Flooring Board Compressed Fiber Cement Board
Product Introduction:
Fiber Cement Board is a stable performance and light weight building &decoration board used cement as major and natural fiber reinforced, with the process of pulping, emulsion, forming, pressing, autoclaving, drying and surface treatment.With the sanding surface, thickness uniformity is better and grain is clearer. And because of the cement,the strength is higher, and waterproof performance is much better.
Product | Fiber Cement Board Flooring Panel |
Dry Density(g/cm3) | 1.2-1.3 |
Water absorption (%) | 33-40 |
Wet expansion (%) | 0.2 |
Water Content(%) | 13-18 |
Bending Strength(Mpa) | 16-20 |
| Shrinkage rate(%) | 0.1-0.15 |
Frost resistant | No delamination and crack after 25cycles under freezing and thawing |
| Water penetration | No water drop on the board surface after 24hours |
Packing:
1. Strong wooden pallet(Standard Export Package)
2. Corner protective
3. Plastic Film
4. Protect Board
Product Application:
It can be used for interlayer floor .It is an inorganic material with light weight, high density, high strength, high flatness, non-combustibility and non-radioactivity. It can be used for the interlayer floor of adding layer building, such as office and commercial residential building.
Main Features:
1. 100% Asbestos Free
2. Excellent Fire Resistant
3. Excellent Moisture / Water Resistant
4. Good Heat and Sound Insulation
5. High Strength
6. Stable Dimensions
7. Durability and long service life
Specification:
(1). Thickness: 18-24mm
(2). Standard size: 1220*2440mm or 1200*2400mm
(3). Note: other specification is available
Installing Method:
1. Galvanized Metal Frame
a.The top and bottom keels are fixed respectively top floor and on floor with expansion bolts.
b.The vertical keel should be aligned well according to the requirement (generally being 612 mm) with
laterally supporting keel installed.
2. Board Material Package Fixed
a.Cutting the board material to the dimensions needed (about 10mm lower than wall height)
b.Board material is fixed on keel in anchoring seam way with tapping screw: the interval of tapping screw is generally
about 200~250mm with screws sinking 0.5mm under the board face.
c.The expansion seam of about 4mm between boards should be kept.
d.The shrouding should be fixed from the middle to the four sides and cannot be operated at multipoint simultaneously
to avoid generating inner stress to make board material bucking.
e.Before board being packaged and fixed, depending the needs, glass cotton or rock cotton can be filled.